Many customers think that the computer engraving machine is doing rough work, and there is no need to take any preventive measures when it rains. In fact, this is wrong. Through the recent telephone interview and the feedback from the customers who use the CNC engraving machine, we feel that some faults are completely unnecessary. , Let’s make the following suggestions:

1. There are many thunderstorms in summer. The engraving machine must be well grounded to reduce static interference, improve machine stability and protect operators.

2. Do not place the engraving machine in a place where the humidity or air humidity is greater than 35%. The shape of the engraving machine is relatively solid with a steel structure or cast iron structure, but the “brain” of the engraving machine is all electronic components composed of circuit boards. The air is used to produce unnecessary faults such as short circuits.

3. Summer is generally the peak period of residential electricity consumption and is often accompanied by thunderstorms, and the voltage of the power supply line is often unstable. This often shows that the main shaft of the engraving machine stops rotating on the engraving machine. The engraving machine with a lower configuration It will also cause the driver to overload and burn out. It is recommended that customers connect the corresponding type of voltage stabilizer under the guidance of our technicians to reduce unnecessary losses.

As mentioned above, we should pay attention to the use of the engraving machine in the rainy season in summer. You should always remember that, and I hope it will be helpful to everyone！

Released by Jinan APEX Machinery Equipment Co., Ltd.